We've made the entire process as "peel and stick" as possible.

Here is the entire process -from start to finish.

1. Pair your sensor to the package-assigned appliance.
   
   
2. Clean and prep sensor installation location (a 4"x4" area is more than enough) with a provided alcohol pad.
   
   
3. Heat the prepped area -just warm enough to the touch.
   
   
4. Peel the protective film off the sticky tape strips.
   
   
5. Press and hold the sensor with adequate pressure to the prepped area for 30-seconds.
   
   
6. Repeat this process for all sensors.